Holmatro CU 4007 Mode D'emploi page 34

EN
7.7 The cutting performance is poor
/i
Possible cause
The blades are damaged.
8 Maintenance
8.1 General
For standard installation instructions, refer to the Service & Support section of the Holmatro website.
Proper preventive maintenance of the equipment preserves the operational safety and extends the life
of the equipment.
WARNING
When performing maintenance activities, always comply with the relevant safety regulations.
Wear the prescribed personal protection equipment.
8.1.1 Dangerous substances
WARNING
Used or leaked fluids, and any other products consumed during the activities, must be
collected and disposed of in an environmentally responsible way.
8.2 Maintenance materials
/i
Application
Steel parts
Hydraulic couplers
Hinge pins
34
Type of maintenance material
WD-40 preservative oil
Tectyl ML from Valvoline (long term preservation)
WD-40 preservative oil
Teflon lubricating oil
916.000.967_005
Solution
Have them replaced by a Holmatro Certified
Technician.
Amount
As required
As required
As required
As required
CU4007