Stacked Installation (Example Of 1 Or 4 Modules On Sub318) - dB Technologies VIO L1610 Manuel D'utilisation

STACKED INSTALLATION (EXAMPLE OF 1 or 4 MODULES ON SUB318)

• It is possible to install a maximum of 4 modules in stacked configuration on DRK-210
flybar.
• Use the DBTECHNOLOGIES COMPOSER to set the project parameters, for safety reasons.
• Position DRK-1610 fly-bar on SUB 318 (installed on a flat surface). For further details on
this accessory, refer to the complete manual.
• Add VIO-L1610 modules one by one, with the previously-calculated angle, as shown in
the MECHANICS
• Make sure that the local parameters of the different modules are correctly set on the
single amplifier panels. In particular, verify according to the project the Speaker Coupling
and High Frequency Compensation settings. As an alternative, all parameters can be
remotely edited in real time or at a later stage in case of line array connection through
the RDNet network (AURORA NET). Nevertheless, project initial settings should at
least be physically repeated on the VIO-L1610 modules before installation. For further
information see
• Make the audio daisy-chain, RDNet and power connections as described in previous
paragraphs.
WARNING
•
VIO-L1610
56
paragraph.
DSP PRESET PARAMETERS AND REMOTE CONTROL
!
If the support surface presents
even the slightest inclination, it is
necessary to properly fasten using
the appropriate mechanical means
and/or installation straps.
English
section.
Code 420120324 REV. 1.0