dB Technologies VIO L1610 Manuel D'utilisation page 46

English
In the event that only one engine is being used in a flown
configuration, "SINGLE" indicates the position of the
single hook to use on DRK-210 (which requires graduated
positions described by a label placed on the fly-bar).
In addition, there is a "FRONT" or "REAR" direction for
directing the hook for the engine.
In the case of "FRONT", the reference (shown in the figure
below and shown as LOAD ADAPTOR REFERENCE SIDE),
should be placed toward the front of the line array, in the
case of "REAR", it should be directed toward the rear of
the line array.
If instead two engines are used, the hooks should always
be placed at the ends of the fly-bar (in this case, the
direction of the placement is irrelevant).
For any other information on the dBTechnologies
Composer software, see the relevant manual, available for
free download from: www.dbtechnologies.com.
LOAD ADAPTOR REFERENCE SIDE
GRADUATED LABEL ON A SIDE OF THE FLY-BAR
VIO-L1610
Code 420120324 REV. 1.0
46