Audio And Rdnet Signal Connection And Daisy Chain - dB Technologies VIO L1610 Manuel D'utilisation

AUDIO AND RDNET SIGNAL CONNECTION AND DAISY CHAIN

The figure above shows a general connection where a module 1 is over module 2 as well as the audio
and network connections. To this end, use the not supplied cables with XLR (audio) and etherCON/
RJ45 (network) connectors. For further information on the available types of cables, refer also to the
image in next page.
• For the audio connection, connect the cable originating from MIXER/LINE to the BALANCED
AUDIO INPUT (A) of module 1 of the line array. Re-link the signal between the first and the
second module. For this purpose, connect the output BALANCED AUDIO OUTPUT/LINK (B) of
module 1 to the BALANCED AUDIO INPUT (C) of module 2.
• Repeat the operation between the second and the third module and so on, until all modules of
the line array are connected.
• For network connection, connect DATA IN connector (A) of module 1 to remote controller (RDNet
CONTROL 2 or RDNet CONTROL 8). Re-link the signal by connecting DATA OUT (B) of module 1 to
DATA IN (C) of module 2.
• Repeat the operation between the second and the third module and so on, until all modules of
the line array are connected.
VIO-L1610
50
MODULE 1
MODULO 2
!
WARNING
• Replace any damaged cable to prevent malfunctioning and sound poor
quality.
English
Code 420120324 REV. 1.0