Publicité
Note: ask your local dealer about
which mounting materials (wall
plugs and screws) to use for your
masonry.
Assembly
To assemble the product you
will need the following tools (not
included in the package contents): a
suitable drill, measuring tape, and a
screwdriver or spanner.
1. Remove the protective cover (2).
2. Place the product (1) in the
desired position and mark four
holes with a pencil (Fig. B).
Note: for easier assembly, fold the
product up and insert the locking pin
(1a) into the top hole.
3. Use the corresponding tool to drill
four holes into the marked points
(Fig. B).
IMPORTANT! Ensure a distance of
53mm between the horizontal holes
and 48mm between the vertical
holes.
4. When installing the product on
masonry, insert one wall plug (not
included in the package contents)
into each hole.
5. Mount the product onto the wall
with suitable mounting materials
(not included in the package
contents).
8
GB/IE/NI
Use
1. Remove the locking pin (1a) and
fold the product out.
2. Insert the locking pin (1a) into the
bottom hole between two of the
product's steel struts (Fig. C).
3. When the product is not in use,
remove the locking pin and fold
the product up.
4. Insert the locking pin (1a) into
the top hole to lock the product
(Fig. D).
Note: fold the product up in the
event of wind speed of 28km/h and
higher!
5. When the product is not in use,
pull the protective cover (2) over
the product (1) and tighten the
protective cover with the cord
(2a) (Fig. E).
Storage, cleaning
Leave the product open to dry. Only
pull the protective cover over the
product if it is dry.
Clean the product with a damp cloth
and wipe dry afterwards.
IMPORTANT! Never clean the
product with harsh cleaning agents.
Privacy protection fan and protective
cover:
Publicité
