Publicité
Jandy
Infinite WaterColors
®
Figure 2. Jandy Infinite WaterColors Wiring Diagram
5.1.1 Assign Lights
1. From the System Setup page, select Light Setup
and Assign Lights.
2. From the Assign Lights pop up, choose proceed to
continue the process.
3. On the Light the Zone Setup page, select a light
in order to move it to a different zone and follow
further instructions in the app.
NOTE: When exiting the Light Zone Setup page, the lights will
turn off.
Lights have to be assigned to a zone in order to rename
the zone.
5.1.2 Name Light Zones
1. Go to > System Setup > Light Setup > Zone Name.
2. From the Edit Zone Name pop up, enter the zone
name and choose OK.
5.2
Turn Lights On/Off
1. Open the app on your device.
2. From the My System page, select your pool.
3. Choose the equipment page.
4. Turn zone lights on/off by tapping the toggle to the
right of the desired zone.
5.3
Select Colors
1. Open the app on your device
2. From the My System page, select your pool.
5.3.1 Select Custom Color
1. Go to > equipment page.
2. From the equipment page, choose the zone you
want to change color.
3. From that zones page, choose Custom Color.
Pool & Spa LED Lights | Installation & Operation Manual
™
GND
LED 2:
RESET
Turns on
red when
powered
WHT
BLK
120 VAC
2.75 A
Control Board
ORN
ORN
(niched only)
GND
GND
Terminal Bus
Bonding Lug
4. Choose your custom color from the color wheel.
5. Choose Apply to apply the custom color to your
zone.
5.3.2 Preset Colors
1. Go to > equipment page and select the zone you
want to change color.
2. After selecting the zone, then choose from the list
of preset colors to apply that preset color to your
zone.
5.3.3 Preset Color Shows
1. Go to > equipment page.
2. From equipment page, choose the zone you want
to change color.
3. After selecting the zone, then choose from the list
of preset color shows to apply that preset color
show to your zone.
5.4
Adjust Brightness
1. From the equipment page, select the sun icon on
the zone where you want to change to adjust the
brightness.
2. Move the slider bar up or down with your finger and
then click apply to change the brightness.
Section 6. Additional Online
For information on the following, please refer to the
online manual:
– Product Overview
– OneTouch Setup
– Amazon Alexa Light Control
– Troubleshooting
LED 1:
Continuously
Flashes
Green When
Communicating
RS485 to
Automation
14 VAC Output 300W
Content
ENGLISH
Page 7
Publicité
