Publicité
▶5. Close the lid 12.
▶6. Use both hands to press firmly on the edges of the lid 12. They
ES
must audibly click into place.
PT
EN
FR
▶7. Press the button The film bag is first vacuum-packed and then
sealed. The LED goes out when the process is complete.
NOTE: If the LED 4 does not go out and the noise of the vacuum
pump does not stop, despite the fact that no further air is being
sucked out of the film bag, cancel the process. Check that the film
bag is in the correct position in the device, and check for leaks.
▶8. Simultaneously, press buttons 9 in order to release the lock of
the lid 12.
▶9. Open the lid 12 and remove the bag.
▶10. Check the welding seam. It should be a smooth creaseless seam
CLEANING AND STORAGE
DANGER! Risk of injury
through burning/scalding!
•
Allow the device to cool down com- pletely
before you clean it or put it away.
•
The welding wire 17 becomes very hot during
operation. Do not touch the hot welding wire
17.
DANGER! Risk of electric
shock!
•
Prior to cleaning, disconnect the mains plug 6
of the device.
DANGER! Risk of electric
shock due to moisture!
•
The device and the power cable with mains
plug 6 must not be immersed in water or
other liquids.
WARNING! Risk of material
damage!
Do not use any sharp or abrasive cleaning agents.
Instruction manual
CLEANING
In order to ensure the proper function and the full capacity of your
device, clean it regularly.
▶Wipe down the housing of the device with a damp cloth.
▶Prior to the next use, the device must be completely dry.
COLLECTOR
▶1. Grasp the centre or both outer ridges with your fingers and
▶2. Drain the liquid.
▶3. Rinse the collector 18 under warm dishwater or place it in the
▶Make sure it is dry before inserting it. 4. Insert the collector 18 into
SEALING RING
▶1. Grasp the sealing ring 16 with two fingers and lift it off upwards.
▶2. Rinse the sealing ring 16 under warm dishwater. Make sure it is
▶3. Replace the sealing ring 16 in the respective form inside the
▶NOTE: the sealing ring 16 is a wearing part. Due to the high contact
9.2 STORAGE
WARNING! Risk of material damage!
During storage, the lid 12 must not be locked, but only loosely
closed. Permanent locking could damage seals 11 and 16.
▶Figure B: Wind the power cable 6 around the cable spool 23 at the
▶• Store the device so that it is protected against dust and dirt and
TROUBLE-SHOOTING
▶If your device fails to function as required, please try this checklist
carefully lift the collector for liquids 18 out upwards.
dishwasher.
the device from above.
dry before inserting it.
device. Ensure that it lies in smooth contact and is not wavy.
pressure, it will lose its shape over time. In this case, replace it with
a new one (included in the items supplied).
underside of the device. Please note the arrows, which indicate the
direction for winding the cable.
out of the reach of children.
first. Perhaps there is only a minor problem, and you can solve it
yourself.
ref. 07817
Publicité
