Publicité
▶To deactivate the function, press the button 1 again.
▶When the vacuum-packing/sealing process is completed or has
been cancelled, the LED goes out and the function is automatically
deactivated.
▶During the vacuum-packing/sealing process, the Wet function 1 can
neither be activated nor deactivated.
NOTE: This function is not suitable for vacuum-packing liquids, e.g.
soup. These need to be frozen before vacuum-packing.
ACTIVATING THE SOFT FUNCTION
The Soft 5 function reduces the vacuum pressure slightly, so that
pressure-sensitive food (e.g. berries or cake) is not compressed.
▶Press the Soft 5 button before vacuumpacking/sealing to activate
the function. The LED lights up.
▶To deactivate the function, press the Soft 5 button again.
▶When the vacuum-packing/sealing process is completed or has
been cancelled, the LED goes out and the function is automatically
deactivated.
▶During the vacuum-packing/sealing process, the Soft function 5 can
neither be activated nor deactivated.
SEALING BAGS (WITHOUT VALVES)
▶1. Smooth the bag where it is to be sealed.
▶2. Open the lid 12. If necessary, press the buttons 9 first.
▶3. Place the bag in the device. For this purpose, the end of the film
bag must be positioned just before the rear reference ridges 13 and
the side reference ridges 15.
▶4. Ensure again that there are no creases in the film bag especially
in the area above the welding wire 17.
▶5. Close the lid 12.
▶6. Use both hands to press firmly on the edges of the lid 12. They
must audibly click into place.
Instruction manual
▶Press the button 3. The LED lights up. The film bag is being sealed.
NOTE: If you have activated the Wet 1 function, the sealing process
takes a few seconds longer.
▶8. Simultaneously, press buttons 9 in order to release the lock of
▶9. Open the lid 12 and remove the bag.
▶10. Check the welding seam. It should be a smooth creaseless seam.
VACUUM-PACKING AND SEALING BAGS (WITHOUT
VALVES)
D
Ensure that no liquid is sucked in during the extraction of air. If this
nevertheless occurs, immediately interrupt the process by pressing
the active function button again.
▶1. Smooth the bag where it is to be sealed.
▶2. Open the lid 12.
▶3. Place the bag in the device. For this purpose, the end of the film
▶4. Ensure again that there are no creases in the film bag especially
After approx. 5-7 seconds, the LED goes out and the sealing process
is completed.
the lid 12.
ANGER! Risk of electric shock due to moisture!
For vacuum-packing, no liquids must be inside the bag.
bag must be positioned just before the rear reference ridges 13 and
the side reference ridges 15.
in the area above the welding wire 17.
ref. 07817
ES
PT
EN
FR
Publicité
