Quick Boiler Square B 23 Manuel De L'utilisateur page 11

NAUTIC WATER HEATER
Experience gained in nautical field in the last 15 years, allows us to supply a new series of water heater with
innovative characteristics compare with other available heaters.
The advantages, given by Quick Nautic boilers, are:
• high quality of materials ensure the product is both reliable and long lasting.
• Heat exchanger with a large exchanging surface .
• Producing hot water also by means of an electric element, which is provided with an adjustable and safety
thermostat .
• A flange that allow inspection of the interior of the water tank.
• Protection against natural electrolysis by means of a magnesium anode.
• Relief/non return valve that allows discharging of water heater in case of disuse.
• The installation is easy and practical on a flat area.
BEFORE USING THE WATER HEATER READ CAREFULLY THIS INSTRUCTION MANUAL.
IF IN DOUBT, PLEASE CONTACT THE NEAREST "QUICK" DEALER.
WARNING: use this water heater in the applications described in this manual. Don't use the equipment
for any other purposes. QUICK will not be held responsible for damage to equipment and/or personal
injuries cause by a misusage of the equipment.
PAKAGE CONTAINS: water heater - user's manual - warranty card.
INSTALLATION SITE
The water heater has to be placed in a dry and well-ventilated location. This precaution is required, even
though water heaters are made of sea environment resistant materials, since electrical systems are present
(in model provided with). Also if they are installed in environments that are not ventilated condensation
could occur. Condensation could be mistaken for a leak.
SET UP
• Fix water heater on flat plan, as shown in fig. 1, using suitable mountings for the weight of water heater
and for the type of installation site in the boat.
WARNING: the weight of water heater/unit in technical data refers to the empty unit. In order to
have the gross weight add to the empty weight, the water amount. (1 liter of water will almost weigh
1 Kilogram)
• Make hydraulic connections, relating to the input and output of tap water and from the engine cooling to
the heat exchanger, as shown in fig. 2. Make the connections as short as possible between engine cooling
system and heat exchanger.
INSTALLATION
11