Publicité
MOUNTING THE RANGE HOOD
Note 1 : On stainless steel hoods, carefully remove the plastic protective film from all exterior surfaces
of the hood and chimney prior to final installation.
Note 2: At least two people will be required to mount the hood.
WALL DRILLING AND BRACKETS FIXING
1.
Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre of
the area in which the hood will be installed.
2.
Draw a horizontal line at desired height (min 25" above the electric hob or 30" above the gas hob).
3.
Place chimney mounting brackets on the wall 1/8" from the ceiling or upper limit aligning the
centre with the vertical reference line.
4.
Mark the wall at the centre of the holes in the bracket.
5.
Place the hood on the wall with the center to the vertical reference line and make sure the bottom
part of the hood align with the horizontal line.
6.
Mark the wall at the centre of the holes in the hood
7.
Fix the bracket and hood using the mounting screws
MOUNTING THE HOOD BODY
1.
Hook the body onto the screws in the wall
2.
Balance the hood body by slightly adjusting the hood mounting screws
DAMPER (FLAPS) FIXING
1.
Fix the damper (flaps) into the air outlet adapter.
2.
To be sure that the damper (flaps) is locked well on the air outlet adapter, it should be flexible in
opening and closing.
DUCT FIXING
Caution: To reduce the risk of fire, use metal ductwork only.
1.
Attach an adequate length of φ 6" round duct into the recessed area of the air outlet adapter.
2.
Secure the duct connected with the air outlet adapter by using duct tape to seal the joints
Publicité
