Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1. BEFORE INSTALLATION
Warning
Thank you observe the following before installing the system:
• This system is designed to be installed on motorcycle equipped with a 12 volt battery and an electric starter.
• The system runs on 12V DC voltage (12 V DC). Be sure the polarity of each wire.
• Before installation, if all elements of the car are working properly such as contact & engine start, ignition codes, lights and headlights, turn signals, ...
Check after installation all these elements work.
• Do not connect the wire by splice / solder without using lugs. Bad contacts can cause serious system malfunctions and the vehicle also.
• When you connect the ground overall system, it is very important that this ground is completely open and stable (no leaks).
• Ensure that all wire passing in tight spaces are protected by adhesive tape to avoid excessive twisting and degradation of the plastic wire with a risk of
bad contacts.
• Ensure that the wire of the system and all the safety accessories are best hidden in the vehicle as possible, never forget that you install a security system.
• Use a digital multimeter to identify each polarity son, use a test light to locate the wire Tachometer (if necessary).
18
Publicité
Chapitres
Table des Matières
