Beeper XONE Manuel D'installation page 24

5. ADDITIONNAL PROGRAMMABLE FUNCTIONS
To program these functions, it is necessary that you connect YELLOW WIRE ON A 12 V BATTERY FOR ACCESS TO THE PROGRAMMING AND
disconnect at THE END OF PROGRAMMING
4 • PROGRAMMING A NEW REMOTE CONTROL •
On the left of the main unit there is a rubber plug, remove and you will see a button. If possible disarm the alarm by pressing the lock open.
Press and hold the push button during the programming operation. The siren will emit 5 beeps and will sound different (double beep) to indicate that you are in
programming mode.
Press the
Release the button, the remote control programming is complete.
6. PROGRAMMABLE FUNCTIONS AUTOMATIC ACTIVATION
To program this function it is necessary that you connect YELLOW WIRE ON +12V AFTER IGNITION
1 • AUTOMATIC ALARM ACTIVATION •
This function allows you to automatically activate the alarm without having to press a button within 3 min. after switching off the ignition. Otherwise it should not activate this
program.
Activation: Press and hold
Deactivation: Press and hold
memory is confirmed by a melody
Only if you have permanently connected the yellow wire on the +12 V after ignition
and press at the same time 5 times, then release
at the same time on press 6 times, then release
. The buzzer beeps plant 5 times, which means that this function is activated
. The buzzer beeps plant 6 times, which means that this feature is disabled.
24