Additional Programmable Functions - Beeper XONE Manuel D'installation

5. ADDITIONNAL PROGRAMMABLE FUNCTIONS
To program these functions, it is necessary that you connect YELLOW WIRE ON A 12 V BATTERY FOR ACCESS TO THE PROGRAMMING AND disconnect
at THE END OF PROGRAMMING
1 •"PAGER" MODE •
Mode "PAGER" is recommended especially at night so as not to disturb the neighborhood, it can alert you remotely on your remote during an attempted break-in your vehicle. Indeed, once in this
mode, the siren does not sound, only the remote alerts you with beeps
To set this mode, it is necessary that you connect the yellow wire to the center on a 12 V battery.
Activation : Press and hold and simultaneously press 7 times, then release . The main unit buzzer beeps 7 times, which means that this function is activated
Deactivation :Press and hold
and simultaneously press 8 times, then release . The main unit buzzer beeps 8 times, which means that this feature is disabled.
After setting the "PAGER" mode, you must activate the alarm by making a long press on the button.
2 • ALARM 60 sec. •
When the alarm is disabled, if someone attempts to start your motorcycle (brought into contact with the bike), the buzzer will sound and the remote control within 60 seconds. (If you do not press on
after the contact.)
To set this mode, it is necessary that you connect the yellow wire to the main unit on a 12 V battery.
Activation: Press and hold and simultaneously press 1 time, then release . The main unit buzzer beeps once, which means that this function is activated
Deactivation : Press and hold
and simultaneously press two times, then release . The main unit buzzer beeps 2 times, which means that this feature is disabled.
3 • SET LEVEL SENSOR SHOCK SENSITIVITY •
To set this mode, it is necessary that you connect the yellow wire to the main unit on a 12 V battery.
• Keep pressing and press 10 times on , release both buttons simultaneously.
• The main unit buzzer beeps 2 times. The mode setting of the sensitivity is enabled.
• A short press increases the sensitivity level, it is confirmed by 1 beep main unit buzzer
• A short press decreases the sensitivity level, it is confirmed by 1 beep main unit buzzer
• To better adjust the shock sensor setting, give small shocks between each press of the remote control to collect the sensor sensitivity. Each pressure (increase or decrease) is confirmed by a beep
from the main unit buzzer, once at the maximum or minimum setting, the main unit buzzer beeps 2 times.
• Make a long press and release to save the change, confirmed by two beeps of the main unit buzzer
23