Publicité
Les langues disponibles
Les langues disponibles
Trouble or fault
The product or battery gets
very hot.
No water supply to the sys-
tem product
Pump does not start
Nozzle does not spray wa-
ter even though the pump is
working
10
Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
*2435409*
Possible cause
Electrical fault.
Product is not switched on (LED on
the product not showing green)
The supply of water in the tank has
been used up completely.
No tank filter installed
Tank filter clogged
Battery is discharged (LED on the
product does not show)
Water in tank or lines has frozen.
Battery is discharged (LED on the
product does not show)
Water in tank or lines has frozen.
Pump does not start after ON
button is pressed (LED showing
steady green)
Impermissible liquids have clogged
the system.
The nozzle is clogged.
Water in the nozzle is frozen.
Malfunction of the spray lance.
Impermissible liquids have clogged
the system.
2435409
Action to be taken
▶ Switch the product off immedi-
ately, remove the battery, keep
it under observation, allow it
to cool down and contact Hilti
Service.
▶ Switch the product on by
pressing the ON button.
▶ Fill the liquid tank.
▶ Check installation of the tank
filter and, if applicable, install a
tank filter.
▶ Clean or replace the tank filter.
▶ Charge the battery or insert a
charged battery.
▶ Move the product to a warm
place and wait until the ice has
melted.
▶ Charge the battery or insert a
charged battery.
▶ Move the product to a warm
place and wait until the ice has
melted.
▶ Remove the battery and then
re-insert the battery.
▶ If the problem persists, consult
Hilti Service.
▶ Contact Hilti Service.
▶ Clean the nozzles.
▶ Move the product to a warm
place and wait until the ice has
melted.
▶ Contact Hilti Service.
▶ Contact Hilti Service.
English
11
13
15
Publicité
