Hilti NURON LS 15-22 Notice D'utilisation Originale page 16

WARNING
Risk of injury due to chemicals escaping at leaking connections or from a damaged hose. Escaping
chemicals can lead to exposure to the chemical by skin contact, eye contact, inhalation or other means
▶ Before using the spraying device with chemicals, make sure that all connections are secure and leaktight.
▶ Make sure that the hose shows no signs of damage.
WARNING
Risk of injury due to chemicals. Failure to use suitable personal protective equipment can lead to exposure
to the chemical by skin contact, eye contact, inhalation or other means.
▶ Find out about the necessary personal protective equipment.
▶ Wear the personal protective equipment recommended by the chemicals manufacturer or stated in the
safety data sheet for the chemical.
▶ Wear personal protective equipment, eye protection, gloves and protective clothing.
▶ Always wear eye protection compliant with ANSI Z87.1 (CAN/CSA Z94.3)
Before using the liquid sprayer, check the battery (→inserted correctly) and the battery-compartment
cover (→closed).
1. Check that the inlet filter is correctly installed.
2. Fill the liquid tank.
▶ Do not overfill.
3. Change the nozzle, as necessary.
4. Transport the liquid sprayer to the place of work.
5. Press the ON button.
▶ The LED shows green.
▶ The liquid sprayer starts briefly, but no jet of water is discharged.
6. Press and hold down the on/off switch.
▶ The liquid sprayer starts and a jet of water is discharged.
7. Carry out the work.
8. Release the on/off switch.
▶ The liquid sprayer and the water inflow are stopped.
9. To switch the pressure sprayer off manually, press the OFF button.
▶ The LED goes out.
▶ The pressure sprayer is switched off.
If you are going to store the product at near-freezing temperatures, remove all traces of liquids
from the product and all supply lines.
7 Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care of the product
• Carefully remove stubborn dirt.
• Carefully clean the air vents, if present, with a dry, soft brush.
• Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
• Use a dry, clean cloth to clean the contacts of the product.
• Flush the system with water after each use to prevent clogging and cross-contamination of liquids when
the product is next used.
Care of the Li­ion batteries
• Never use a battery with clogged air vents. Clean the air vents carefully using a dry, soft brush.
12 English
11
11
2435409
*2435409*