Stanley SXAE00026 Mode D'emploi page 8

Check first if the negative terminal is connected/grounded to the chassis. If not, contact your
reseller.
Connect the outlet cable to the charger.
§ Output cable with clamps
Connect the red clamp (+) to the positive terminal (+) of the battery, then connect the black
clamp (-) to the earth/chassis of the vehicle (a heavy gauge metal part of the frame or engine
block. Do not connect to the carburetor or fuel lines).
§ Output cable with rings - Optional: SXAE00030
Loosen and remove each nut from the bolts at the battery terminals. Connect the positive ring
(+) to the positive terminal (+) of the battery, then connect the negative ring (-) to the negative
(-) terminal of the battery. Replace and tighten back the nuts to secure them.
In both cases: make sure that the charger outlet lead make tight connections.
3.
Connection to the mains
Plug the power supply lead of the battery charger into the mains.
The power LED "ON" is lighting up green = "Stand by" mode.
4. Selection of the charging mode
Press the button once to activate the unit, and then choose the charging parameters, for the
type of battery and the charging current, on the control panel by pushing the selection push
button when the icon appears. The charging process will start automatically (after this, it will be
not possible to change the settled parameters). Different possibilities:
Current Type
Charge for 12V batteries: 5Ah to 50Ah.
Maintenance charge for 12V batteries: 5Ah to 80Ah.
Suitable for charging WET or GEL batteries.
Charge for 12V batteries: 50Ah to 160Ah.
Maintenance charge for 12V batteries: 50Ah a 250Ah.
Suitable for charging WET or GEL batteries.
Charge for 12V batteries: 5Ah to 50Ah.
Maintenance charge for 12V batteries: 5Ah to 80Ah.
Suitable for charging AGM-START&STOP and AGM-SPIRAL or WET
batteries with temperatures below 5°C.
Charge for 12V batteries: 50Ah to 160Ah.
Maintenance charge for 12V batteries: 50Ah to 250Ah.
Suitable for charging AGM-START&STOP and AGM-SPIRAL or WET
batteries with temperatures below 5 °C.
Power supply function: 13.8V – 5A, max. 80 watts.
To activate: connect to the battery.
This function is used to keep a vehicle's memory banks active while the
battery is being changed or whenever the battery is disconnected from
the vehicle's circuit. CAUTION: IN THIS FUNCTION, THE BATTERY
CHARGER IS NOT PROTECTED AGAINST POLARITY REVERSAL.
RISK OF DAMAGE!
8