Publicité
CAUTION: Do NOT apply flame to the hoses.
Do NOT apply flame or heat to any plastic hosetails.
Do NOT apply sealing compounds to any hose
connections.
•
Secure the ends of all hoses to the hosetails with stainless steel wormdrive hose
clamps, ensuring that all inlet connections are airtight and that all outlet connections
are watertight.
Handle
Store the handle close to the pump in spring clips.
•
Using the hole provided in the stainless-steel handle, secure it with a lanyard to the
mounting surface of the pump.
Operating instructions
Amazon pumps are simple to operate.
•
If your pump is installed through the deck, first swing the white lid of the deck cover
through 180° and snap it into its open position.
•
Then just insert the end of the pump handle into the socket on the rocker arm and
move the handle backwards and forwards.
•
For maximum efficiency, use even strokes through the full arc of travel of the handle.
•
Expect the pump to prime and begin to discharge after a few strokes.
•
After use, remove the handle and return it to its storage position.
•
Close the white lid of the deck cover.
29240-000 Bulkhead
Spare Parts List
Liste des pièces détachées • Ersatzteilliste • Lista dei pezzi di ricambio
Lijst van reserve-onderdelen • Reservdelslista • Lista de piezas de repuesto
Safety Instructions
1. Always install pumps in a position that allows for sustained peri-
ods of pumping, where there is full access to the pump for service.
2. Fix pumps to a flat surface.
3. Secure detachable handles to the vessel by use of a lanyard.
4. Always use marine grade spiral rein-
forced hose (with smooth internal bore) of
the correct size for the pump.
5. Pipework runs should be kept as short
and straight as possible, avoiding rising
and dipping over obstructions.
6. All bilge pumps discharged overboard
must be installed with the overboard dis-
charge well above both static and heeled
waterlines. (Sailboats normally discharge through the transom).
7. For maximum efficiency raise discharge hose at least 12"
(30cm) after it leaves the pump.
8. To minimise risk of blockage fit a strain-
er on the bilge end of the pipework.
Repair Kits Available
Kit
Part No.
A
29246-1000
B
29241-1000
Key
Description
1
OUTLET PORT
2
OUTLET VALVE
3
BODY
4
DIAPHRAGM PLATE
5
DIAPHRAGM
6
CLAMP RING
7
SCREW
8
CON ROD
9
CLEVIS PIN (LONG)
10
ROCKER
11
CLEVIS PIN (SHORT)
13
WASHER
14
HANDLE
15
INLET VALVE
16
INLET PORT
17
WASHER
18
BOLT
3
Description
MAJOR SERVICE KIT
PORTS KIT
Qty. per
Part No.
pump
1
1
1
2
1
1
14
1
1
1
1
1
1
29267-1000
1
1
1
1
Qty. per
repair kit
A
B
1
1
1
1
2
2
1
1
1
1
Publicité
