Publicité
1. Remove crumb trays and
shelves from both ends.
4. Finish removing the conveyor
assembly from the right end of
the oven.
7. The lower fi nger assembly can
be removed complete or the
nozzle can be slid off to reveal
the recessed columnating
plate.
DIRECTIONS FOR DISASSEMBLY
2. Push the spring-loaded coupling
in to disengage the pin in the
shaft. Rotate the shaft so the pin
will not go back in the coupling
slots.
5. Upper fi nger assembly can be
removed complete or the small
handle (left) can be used to slide
nozzle and columnating plate
out before removing the main
body.
8. The columnating plate also has
a slot that must align with a tab
on the fi nger to ensure proper
orientation.
Extruded holes
point up toward the bottom of
the conveyor.
15
3. Lift up the left end of the conveyor
frame so the crumb tray supports
clear the tunnel opening. Push
the conveyor frame through the
tunnel opening.
6. Upper nozzle (with slot) and
columnating plates (with tab).
Extruded holes all point in the
same direction (down toward
the conveyor).
9. The oven body is now ready to
be wiped clean. Reassemble
the fi nger and conveyor parts
in the reverse order after
cleaning.
Publicité
