Manuels Connexes pour Star UltraMax UM1854-NAT
Sommaire des Matières pour Star UltraMax UM1854-NAT
- Page 1 ® CONVEYOR OVEN MODEL UM1854-NAT UM1854-LP Installation and Operation Instructions 2M-Z5649 Rev. K 11/1/07 UM1854...
- Page 2 RETAIN THIS MANUAL FOR FUTURE REFERENCE NOTICE Using any part other than genuine Star factory supplied parts relieves the manufacturer of all liability. Star reserves the right to change specifi cations and product design without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.
- Page 3 SPECIFICATIONS UM1854-NAT, UM1854-LP Gas Rating/Connection: 40,000 BTU/hr (10080 kCal/min)(703kW) 1/2" NPT male pipe connection Gas Supply Pressure: Natural - 5-6" water column (15-30 mBar) Propane - 11-12" water column (27.5-30 mBar) Electrical Supply: Separate 15 Amp 110VAC, single phase, 50/60 Hz service per Oven Approximate Weight (Single Oven with Cart): Installed - 280 Lbs (127.27 kg), Shipping - 350 Lbs (159.09 kg) Dimensions: Width:...
- Page 4 INSTALLATION CODE AND LOCAL CODES WHERE APPLICABLE. NOTICE This appliance must be installed with a stand and casters designed by Star Manufacturing as part of a complete installation. The installation must also include a connector complying with either ANSI Z21.69 or CAN/CGA-6.16 and a quick-disconnect device complying with either ANSI Z21.41 or CAN1-6.9.
- Page 5 Star Service Representative. This service is required by Star in order to assist the purchaser in proper start-up of the oven on site. Please note the specifi c details on the Warranty and make certain that service connections are made to proper utility services.
- Page 6 INSTALLATION INFORMATION THE INSTALLATION INSTRUCTIONS CONTAINED HEREIN ARE FOR THE USE OF QUALIFIED INSTALLATION AND SERVICE PERSONNEL ONLY. INSTALLATION OR SERVICE BY OTHER THAN QUALIFIED PERSONNEL MAY RESULT IN DAMAGE TO THE OVEN AND/OR INJURY TO THE OPERATOR. Qualifi ed installation personnel are individuals, a fi rm, a corporation, or a company which either in person or through a representative are engaged in and responsible for: 1.
- Page 7 2. Put the smoke candle in an 8"x8"x2" cake pan. 3. Insert candle through conveyor tunnel or oven door. (Use Star Smoke Candle 2W-Z5668.) 4. Light the fuse of the smoke candle and immediately center the pan in the oven cavity on the conveyor belt (keeping the oven door closed).
- Page 8 GAS SUPPLY RATING AND SIZING Calculations for pipe sizing must take into account the maximum usage rate of all other appliances in the kitchen or one or more of the appliances will suffer from inadequate or dangerous performance. The 1/2" NPT connection for the oven is generously sized for use in the control box of the oven.
- Page 9 WARNING: To prevent damage to the control valve regulator during the initial turn-on of gas, it is very important to open the manual shut-off valve very slowly. After the initial gas turn-on, the manual shut-off valve must remain open except during pressure testing as outlined in the above steps or when necessary during service maintenance.
- Page 10 (start-up check-out) by an authorized The information contained in this section is provided service technician or a Star Service Technician in for the use of qualifi ed operating personnel. Qualifi ed order to assure the oven is properly installed and in operating personnel are those who have carefully working order.
- Page 11 Please take time to read the following safety To adjust the time and temperature: operating instructions. They are the key to the 1. Press the DOWN and UP arrows ( ) at successful operation of your Ultra-Max Conveyor the same time. Hold for four seconds until the Oven.
- Page 12 DISPLAY INFORMATION after reaching the STORE level. yES indicates that the parameters cannot be changed even When operating the oven, there are different after entering the STORE level. The LOC setting levels of access: can be toggled using the ENTER button ( 1.
- Page 13 BAKE TIME VERSUS TEMPERATURE CONVEYOR SPEED 1. Bake time is actually conveyor speed and is defi ned Bake Time (Conveyor Speed) - As stated previously, as the time the product is actually in the oven. This bake time (conveyor speed) is defi ned as the amount is measured by noting the time when the leading of time elapsed between the time the leading edge of edge of the product enters the oven and the time...
- Page 14 EVERY TWELVE MONTHS A factory authorized service person should: 1. Open and clean the inside of the control box. 2. Check and tighten all electrical components. If maintenance is required, contact your local service company, a factory representative, or Star Manufacturing.
- Page 15 DIRECTIONS FOR DISASSEMBLY 1. Remove crumb trays and 2. Push the spring-loaded coupling 3. Lift up the left end of the conveyor shelves from both ends. in to disengage the pin in the frame so the crumb tray supports shaft. Rotate the shaft so the pin clear the tunnel opening.
- Page 16 CONVEYOR BELT TENSION The conveyor belt of the Ultra-Max Gas Conveyor Oven does not have a tension adjustment. If the belt becomes too loose, a link will have to be removed to tighten. A belt that is too tight will also cause operational problems due to excessive drag.
- Page 17 LIMITED EQUIPMENT WARRANTY All workmanship and material in Star products have a one (1) year limited warranty on parts & labor in the United States and Canada. Such warranty is limited to the original purchaser only and shall be effective from the date the equipment is placed in service. Star's obligation under this warranty is limited to the repair of defects without charge, by the factory authorized service agency or one of its sub-agencies.
- Page 18 DSIC 34 23 26 37 26 37 THS 2 120V M.V. 3 SENSE 4 38 25 PLUG ON BACK OF MOTOR IS SHOWN ROTATED 180° SECOND GENERATION CN5 TO SMALL MOTOR 7 = SPEED (GRD) 6 = SPEED SIGNAL 5 = SPEED (5V REF) 4 = (NOT USED) 3 = TACH (GND) 2 = TACH (+5V)
- Page 19 GM/C - GEARMOTOR & CONTROLLER - CAPACITOR, CIRC FAN MOTOR DSIC - DIRECT SPARK IGNITION CONTROLLER - POWER SUPPLY, 24VDC 150W PS - MOTOR, CIRC FAN - OVEN CONTROL BOARD - COOL DOWN T-STAT - CONTROL BOX TEMP LIMIT (MAN RESET) - COOK CHAMBER TEMP LIMIT (BULB &...
- Page 21 CANDLE, WHITE SMOKE, CONVEYOR OVEN START UP IMPORTANT: WHEN ORDERING, SPECIFY VOLTAGE OR TYPE GAS DESIRED PAGE INCLUDE MODEL AND SERIAL NUMBER Some items are included for illustrative purposes only and in certain instances may not be available. Star Manufacturing International, Inc.
- Page 23 SCREW #8X3/8 B THP STL NP IMPORTANT: WHEN ORDERING, SPECIFY VOLTAGE OR TYPE GAS DESIRED PAGE INCLUDE MODEL AND SERIAL NUMBER Some items are included for illustrative purposes only and in certain instances may not be available. Star Manufacturing International, Inc.
- Page 25 UPPER FINGER WELDMENT G9-Z5648 UPPER FINGER BAFFLE IMPORTANT: WHEN ORDERING, SPECIFY VOLTAGE OR TYPE GAS DESIRED PAGE INCLUDE MODEL AND SERIAL NUMBER Some items are included for illustrative purposes only and in certain instances may not be available. Star Manufacturing International, Inc.