RESTRAINT REQUIREMENT
1. The installation shall be made with a gas
connector that complies with local codes for
connectors for movable gas appliances and a
quick-disconnect device that complies with local
codes for such devices in use with gas fuel.
2. The installation of the restraint must limit the
movement of the oven(s) without depending on
the connector, the quick disconnect device, or
associated piping to limit the oven movement.
3. If the restraint must be disconnected during
maintenance or cleaning, it must be reconnected
after the oven has been returned to its originally
installed position.
OPERATING INSTRUCTIONS
DO NOT ATTEMPT TO OPERATE THE OVEN until
connection of utility service and installation has been
fully inspected (start-up check-out) by an authorized
service technician or a Star Service Technician in
order to assure the oven is properly installed and in
working order. The warranty becomes effective
upon verifi cation of proper installation.
A
B
DO NOT WORK AROUND THE CONVEYOR
BELT WITH LONG HAIR, LOOSE CLOTHING,
OR DANGLING JEWELRY.
CAUGHT IN THE BELT COULD RESULT IN
DISMEMBERMENT OR FATAL INJURY.
Unless specifi ed otherwise, conveyor travel is
factory set for left to right operation when facing the
front of the oven. If a direction change is required,
refer to "DISPLAY INFORMATION," section 3 for
instructions on how to program the controller for a
direction change. In addition, the conveyor belt must
be changed to travel in the new direction.
SAFETY OPERATING INSTRUCTIONS
The information contained in this section is provided
for the use of qualifi ed operating personnel. Qualifi ed
operating personnel are those who have carefully
read the information contained in this manual, are
familiar with the functions of the oven and/or have
had previous experience with the operation of the
equipment described. Adherence to the procedures
recommended herein will assure the achievement
of optimum performance and long, trouble-free
service.
10
HOLLOW WALL STUD
OR MASONRY WALL
C
CAUTION
GETTING