INVENTOR EP3-ION-10L Manuel D'utilisateur page 8

• Do not use the socket if it is loose or damaged.
• Do not operate your appliance in a wet room such as a bathroom or laundry room.
• Do not use this product for functions other than those described in this instruction
manual
• Contact the authorised installer for installation of this unit.
• If the dehumidifier is knocked over during use, turn off the unit and unplug it from the
main power supply immediately. Visually inspect the unit to ensure there is no damage.
If you suspect the unit has been damaged, contact a technician or customer service for
assistance.
• In a thunderstorm, the power must be cut off to avoid damage to the machine due to
lightning.
• To reduce the risk of fire or electric shock, do not use this fan with any solid-state speed
control device.
• Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar
coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic
area and where it will not be tripped over.
• Do not open the unit during operation.
• When the air filter is to be removed, do not touch the metal parts of the unit.
• Do not operate the unit with damaged cord. Dispose the unit or return it to an authorized
service facility for proper checking and/or repair.
• Hold the plug by the head of the power plug when taking it out.
Electrical Information
l
• The manufactures nameplate is located on the rear or side panel of the unit and contains
electrical and other technical data specific to this unit.
• Be sure the unit is properly grounded. To minimize shock and fire hazards, proper
grounding is important. The power cord is equipped with a three-prong grounding plug
for protection against shock hazards.
• Your unit must be used in a properly grounded wall receptacle. If the wall receptacle
you intend to use is not adequately grounded or protected by a time delay fuse or circuit
breaker(the fuse or circuit breaker needed is determined by the maximum current of
the unit. The maximum current is indicated on the nameplate located on unit), have a
qualified electrician install the proper receptacle.
• Ensure the receptacle is accessible after the unit installation.
• Do not use extension cords or an adapter plugs with this unit. However, if it is necessary
to use an extension cord, use an approved Dehumidifier extension cord only (available at
most local hardware stores).
• To avoid the possibility of personal injury, always disconnect the power supply to the
unit, before installing and/or servicing.
• All wirings must be performed strictly in accordance with the wiring diagram located on
the middle baffle of the unit (behind the water bucket).
Take note the fuse specifications
l
The unit s circuit board (PCB) is designed with a fuse to provide overcurrent protection.
The specifications of the fuse are printed on the circuit board, such as: T 3.15A/250V (or
350V), etc.
NOTE: All the pictures in the manual are for explanation purposes only. The actual shape
of the unit you purchased may be slightly different, but the operations and functions are
the same.
8
EN