INVENTOR EP3-ION-10L Manuel D'utilisateur page 25

The unit makes a loud noise when operating
The air filter is clogged.
l
The device is tilted instead of being in an upright position.
l
The floor surface is not flat.
l
Frost build up on coils
This is normal. This unit is supplied with an Auto defrost feature.
l
Drain hose water leakage
Check the correct installation of the drain hose.
l
Check for any blockage or damage of the drain hose.
l
Understanding Error and Protection codes
Error Codes:
AS - Humidity module sensor error - Power off unit and temporarily unplug allowing
device to reset. If error persists, call for service.
ES - Tube Temperature sensor error - Power off unit and temporarily unplug allowing
device to reset. If error persists, call for service.
EC - Refrigerant leakage detection - Unit auto detects refrigerant leakage, if this occurs
the EC code will appear. Power off unit and temporarily unplug allowing device to reset.
If error persists, call for service.
Protection Code:
P2 - The water tank is full or not installed correctly - Empty the tank or install it properly.
In the event of any of the above-mentioned malfunctions, turn
off the unit, and check for any obstructions. Restart the unit, if
the malfunction persists, turn off the unit and unplug. Contact
the manufacturer or a qualified technician for service.
EN
25