INVENTOR EP3-ION-10L Manuel D'utilisateur page 18

PLUS (+) AND MINUS (-) CONTROL BUTTONS
Humidity Set Control Button
Press the relative buttons (PLUS or MINUS) to set your desired humidity level within a
range of 35% RH (Relative Humidity) to 85% RH (Relative Humidity) in 5% increments,
each time one of the relative buttons are pressed.
• For drier air press the "Minus" (-) button to set a lower percent value (%).
• For damper air, press the "Plus" (+) button to set a higher percent value (%).
ION
Press the + and - buttons simultaneously for 2 seconds to activate the ionizer. Ions will
be released in the atmosphere to purify the air and remove unpleasant and unhealthy
particles. By pressing once again for 2 seconds the + and - buttons, this function will
be deactivated.
TIMER
Press the "TIMER" button to initiate the auto START or auto STOP function in
combination with the PLUS (+) and MINUS (-) buttons. The "TIMER" indicator and the
Display will turn on.
• When unit is on, press the Timer button to activate the auto STOP
function. When the unit is off, press this button to activate the auto START
function.
• Press the (+) or (-) button to change the time by 0.5 hour increments, up
to 10 hours or by 1 hour increments up to 24 hours. The control panel will
then count down time remaining until START or STOP.
• The time selected will be stored within 5 seconds and the main display
will automatically return to its previous state.
• When the auto START or auto STOP functions is set the Timer indicator is
lit identifying that ON or OFF timers are programmed.
• Turning the unit ON or OFF at any time or changing the timers setting to
0.0 will terminate the Auto Start/Stop function.
• When the control panel window displays code "P2", the Auto Start/Stop
function will be terminated.
18
Note: This function can't work simultaneously
with the "CONT." function activated.
Note: The timer function can either be set to
ON or OFF. Setting ON and OFF simultaneously
is not possible.
EN