Publicité
I N S T A L L A T I O N P R O C E D U R E S
50.80
Ø
2"
28.19
Ø
1 1/8"
Adjustable
Ajuster en
hauteur
1
MOUNTING THE VERTICAL SPRAY
A. Apply a ring of plumbers putty
to the underside of the vertical spray
(21).
B. Insert the vertical spray inside
the bowl.
C. From underneath, slide the rub-
ber washer (22), the metal washer
(23) and tighten firmly with hexago-
nal nut (24).
Products info.: www.aquabrass.com
last revision: 05/23/2013
46.74
Ø
1 13/16"
135
2"
MAX
Ø 7 /16"
ATTENTION:
MAKE SURE TO FLUSH THE HOT AND COLD WATER
SUPPLY LINES BEFORE BEGINNING THE INSTALLATION.
san remo 8026
40.01
1 9/16"
16.51
Ø
5/8"
2
INSTALLING THE DRAIN
A. Apply a ring of plumbers putty
around the upper part of the drain(42)
21
and insert it in the drain hole.
B. From underneath, slide the cone
shaped washer (43) over the drain body
with the cone side up. Now add the fric-
22
tion washer (44) and secure the drain in
position by threading on the hexagonal
nut (45). Do not overtighten. Wipe off
23
the excess putty with a clean soft cloth.
C. Thread on the T section (46) of the
24
drain. Make sure the washer (51) is
there to seal properly. You will need to
position the T towards the back of the
bidet in order to connect the pop up rod.
D. Slide the horizontal rod (48) with the
nylon washer(50) into the T and secure in
place with the compression nut (49).
E. Thread on the tail piece (47). Make
sure the connection is properly sealed.
Bidet faucet 4 holes
4 hole bidet set
robinet de bidet à 4 trous
139.70
52
INS-SCB1-2-E
Updated 14-09-04
42
43
44
45
51
46
47
aquabrass.com
Publicité
