Checking the rubber boot and the main shaft
Ingrédients :
-
Grease STRUCTOVIS POO
-
Water
Replace if required
-
Rubber foot (ref 32432)
Preliminary Steps
-
Switch off the machine using the pause button,squeezers in upper position
-
Unplug the machine
Operating procedures:
-
Follow the preliminary steps
-
Remove the rear protective cover and rear upper panel.
-
Check boot (1). Replace if required (presence of tears)
-
Remove lower clamp and lift the boot
-
Clean the main shaft with water, and dry it.Grease if necessary.
Edition du 04-2005
408080 en ma 2014.06
Sheet n°3
Matériel :
- Screwdriver
R
½
20/39
Page 20