Sennheiser In-ear monitor evolution wireless ew 300 IEM Notice D'emploi page 37

µ
1 / " (6.3 mm) jack plug
4
balanced unbalanced
1 / " (6.3 mm) stereo jack plug
4
for headphone connection
Connecting the pre-amplifier/mixing console
Connect the outputs from the pre-amplifier/mixing console/etc. to the
1
/ " (6.3 mm) jack sockets
4
Both balanced and unbalanced connection is possible.
Note:
Any device that is only suitable for mono operation must be connected
to jack socket µ. In this case, the stereo operation must be switched
¸
off via the menu.
Switching the transmitter on/off
Press the
To switch the transmitter off, press the
appears on the display. You can then release the button.
After a power failure, the device returns to the previous setting (ON/OFF).
Connecting the headphones/monitoring the audio signal
Connect the headphones to the headphone output (PHONES)
for monitoring the audio signal. Only connect headphones with a
1
/ " (6.3 mm) stereo jack plug.
4
Use the headphone volume control
Attention: First set the volume control to the lowest volume by turning
it to the left as far as possible!
Volume up? – NO!
When people use headphones, they tend to choose a higher volume
than with loudspeakers. Listening at high volume levels for long
periods can lead to permanent hearing defects. Please protect your
hearing, Sennheiser headphones have an excellent sound quality even
at low volumes.
µ
(left or MONO) and
POWER button to switch the transmitter on.
¸
(right).
POWER button until "OFF"
to adjust the volume.
39