Télécharger Imprimer la page

AEG LAVATHERM 65270AC Notice D'utilisation page 35

Publicité

Les langues disponibles

Les langues disponibles

• drain the water container
HINTS AND TIPS
ECOLOGICAL HINTS
• Do not use fabric softener to wash
and then dry. In the tumble dryer
laundry becomes soft automatically.
• Use the condensate as distilled wa-
ter, e.g. for steam ironing. If necessa-
ry clean the condensate before (e.g.
with a coffee filter) to remove possi-
ble small pieces of fluff.
• Always keep the airflow slots on the
bottom of the appliance clear.
• Use the load volumes specified in the
programmes chapter.
• Make sure that is good airflow in the
appliance installation position.
• Clean the filter after each drying cy-
cle.
• Spin good the laundry before drying.
AVERAGE LAUNDRY WEIGHTS
bathrobe
quilt cover
man's work shirt
man's pyjamas
sheet
tablecloth
man's shirt
night dress
pillow case
towelling towel
blouse
ladies' briefs
men's underpants
napkin
tea cloth
All manuals and user guides at all-guides.com
1200 g
700 g
600 g
500 g
500 g
250 g
200 g
200 g
200 g
200 g
100 g
100 g
100 g
100 g
100 g
(See chapter CARE AND CLEANING.)
WATER HARDNESS AND
CONDUCTIVITY
Water hardness can be different for dif-
ferent locations. Water hardness has an
effect on the water conductivity and the
operation of the conductivity sensor in
the appliance. If you know the value of
the water conductivity you can adjust
the sensor to dry with the better results.
To change the sensor conductivity:
1. Turn the programme dial to availa-
ble programme.
2. Push at the same time the Delicate
(Behoedzaam) and Anticrease (Anti-
kreuk) buttons and hold down until
one of the these symbols go into
view on the display:
low conductivity <300 μS/
cm
moderate conductivity
300-600 μS/cm
high conductivity >600
μS/cm
3. Push the Start Pause button again
and again until you set necessary
level.
4. To memorise setting push at the
same time the Delicate (Behoed-
zaam) and Anticrease (Anti-kreuk)
buttons.
WATER CONTAINER FULL —
INDICATION
By default the indication LED is always
on. It comes into the view at the end of
the cycle or when the water container is
full. When you use an external equip-
ment to drain the container, the LED
can be off.
To activate or deactivate the indication:
1. Turn the programme dial to availa-
ble programme.
2. Push at the same time the Delicate
(Behoedzaam) and Delay Start (Star-
tuitstel) buttons and hold down until
you see the correct setting:
ENGLISH
35

Publicité

loading