Publicité
Connect to Drain
1
Connect drain hose
Green clamp
Black drain hose
connector
Place towel under drain hose to catch any water in drain
hose. Place the small green drain hose clamp onto the
small end of the drain hose. Push the new drain hose
into the black drain hose connector up to the drain hose
stop.
2
Slide clamp onto connector
Green clamp
Black drain hose
connector
Using pliers, squeeze open the small green drain hose
clamp and slide onto connector between stops.
3
Hose clamp final position
Green clamp
Black drain hose
connector
After hose is connected, remove towel.
If needed, see website for animated representation of
this step. Visit www.jenn-air.com/drain under FAQ tab.
20
Drain hose
Drain hose stop
Stop
Stop
Drain hose
Drain hose stop
Stop
Stop
Drain hose
Drain hose stop
Stop
Stop
Make Direct Wire Electrical
Connection
NOTE: If the power supply cord was connected earlier,
proceed to "Secure Dishwasher in Cabinet Opening"
section.
Option B, Direct Wire:
1
Direct Wire-—Route cable
into terminal box
Route cable so that it does not touch dishwasher motor
or lower part of dishwasher tub. Pull cable through UL
Listed/CSA Certified strain relief in terminal box. Strain
relief is not supplied with the dishwasher. Customer
must purchase a 7/8" screw-in type strain relief.
Select UL Listed/CSA Certified twist-on wire connectors
(not included) rated to connect your household wiring to
16-gauge dishwasher wiring.
Publicité
