Jenn-Air JDTFS24HL Instructions D'installation

FOR CUSTOM 18" AND 24" WOOD DOOR PANEL
IMPORTANT: Before installing your dishwasher, please use this instruction sheet as a supplement to the Installation Instructions.
Custom Panel Models Only
Gather these additional tools and parts before starting attach-
ment of the custom panel. Read and follow the instructions
provided in this instruction sheet.
Additional Tools Needed:
Power Drill
Phillips-head screwdriver or magnetic bit
Parts Supplied with Custom Panel Models:
1 ST3.5X45 X4
NOTE: The screws supplied are used for only a 0.59" (1.5 cm)
thick wooden panel. If the wooden panel is less than
0.59" (1.5 cm) thick, customer must purchase screws locally.
1.
Slide panel onto door
Align the studs on the custom panel to the keyhole slots on the
door assembly. Ensure that the studs and brackets are engaged
in the keyhole slots. Slide panel down until the top surface of the
panel is flush with the top of the door.
W11246222A
INSTALLATION INSTRUCTIONS
2.
Secure the door panel
Secure the door panel by inserting the four anchor screws
provided into the inner door frame holes. See screw hole
locations in the above illustration.
3.
Check the spring tension
Open and close the door to check the spring tension of the door.
4.
Adjust spring tension (if needed)
Door spring adjustment
screws
If needed, adjust the spring tension by using a Phillips-head
screwdriver. Turn screws clockwise to increase tension or
counterclockwise to decrease door tension.