Lawn-Boy Silver Serie Manuel De L'utilisateur page 8

Adjusting the Handle Height
Squeeze the bottom of
the handle halves
together (as shown) and
change the handle holes
in which the pins (A) are
mounted, as follows:
Raise the handle
using hole (B).
Lower the handle
using hole (C).
Operation
Starting the Engine
1. Firmly push in the
primer 3 times with your
thumb, holding the
primer in for a second
before releasing it each
time.
Note: If the air
temperature is below
55 F (13 C), firmly push
the primer in 5 times.
2. Hold the blade
control bar (A) against
the handle.
3. Start the engine using the recoil starter.
4. If the mower does not start in 1 or 2 pulls, press
the primer button 1 or 2 times and try starting it again.
8
C
B
A
m-5572
A
m-5644
m-5645
3350-619
m-5614
Using the Self-propel Drive
Model 10359C only
To operate the self-propel drive, squeeze the
self-propel drive bar (A) toward the handle and hold it.
A
To disengage the self-propel drive, release the
self-propel drive bar.
Note: The maximum self-propel ground speed is
fixed. To reduce the ground speed, increase the
space between the self-propel drive bar and the
handle.
Stopping the Engine
To stop the engine, release the blade control bar.
Important: When you release the blade control bar,
both the engine and blade should stop within
3 seconds. If they do not stop properly, stop using
your mower immediately and contact your Authorized
Service Dealer.
m-5612
m-5660
m-5656