Publicité
Les langues disponibles
Les langues disponibles
F58F DUCT MOUNTED ELECTRONIC AIR CLEANER
Choose Location
Choose a location that is readily accessible for regular
inspection and cleaning. Allow at least 13 in. [330 mm] in
front of the access door for removing the prefilter and
electronic cell. Allow enough room above the power supply
so it can be serviced without removing pipes, ducts, or
other heating system components.
must
The air cleaner
be installed where the temperature
will not exceed 40°F to 125°F (4°C to 52°C).
Choose Mounting Position
WARNING
Heavy Equipment.
Can cause injury or equipment damage.
Do not mount the air cleaner with the access door
facing down. If the access door faces down, the
latch may not hold, and the cell and prefilter can
fall unexpectedly. Also, nothing holds the cell and
prefilter in place when the access door is opened.
1
1
ALLOW 13 IN. [330 MM] MINIMUM FOR CELL AND SCREEN REMOVAL.
69-0976B—1
Fig. 1. Typical multiple installation of F58F Electronic Air Cleaners.
The air cleaner can be mounted in any position except with
the access door facing down.
Multiple electronic air cleaner installations are needed for
many commercial systems. Air cleaners can be mounted
back-to-back.
Carefully plan the number of air cleaners and positions
before beginning installation. To visualize the plan of
installation, temporarily arrange the desired number of air
cleaners on the floor. Consider the air cleaners total
dimensions, clearance and accessibility before selecting a
location.
Back-to-Back Mounting
When mounting two cabinets back-to-back, allow at least
13 in. (330 mm) on each side (total of 26 in. (660 mm)) to
remove cells and protective screens for cleaning. See
Fig. 1. Allow 1/4 to 3/8 in. (6.4 to 9.6 mm) between
adjoining back ends of the cabinet for protruding tray tabs.
Tray tabs extend 1/8 in. (3.2 mm) and must not be bent.
2
1
M5769
Publicité
