Broan RHVBB20SM Mode D'emploi page 13

OPERATION
Controls
Light switch: turns the lamps on and off.
Blower switch: makes it possible to select the motor operating
speed.
LO
OFF
HI
MAINTENANCE
ALWAYS SWITCH OFF THE ELECTRICITY SUPPLY BEFORE CARRYING
OUT ANY OPERATIONS ON THE APPLIANCE.
Grease Filter
The grease filter should be cleaned frequently. Use a warm detergent
solution. Grease filter is dishwasher safe.
To remove the grease filter: remove the (4) screws and take off the
metal grid. Take off the metal wires and remove the grease filter.
GREASE
FILTER
Non-Ducted Recirculation Filter
The Non-Ducted Recirculation filter should be changed every 6 months.
To remove the Non-Ducted Recirculation filter:
1. Remove the grid taking off the (4) "A" screws 3.9x6mm (Fig. 3).
2. Remove the metal wires (Fig. 4) and replace the Non-ducted
recirculation Filter.
Cleaning
Occasional care will help preserve its fine appearance.
• Clean with warm water and mild detergent only.
• Follow all cleaning by rinsing with clear water.
• Wipe dry with clean, soft cloth.
Light bulbs
This range hood requires two 40-Watt light bulbs (not included).
To change bulbs:
1. Remove the 2.9x9.5mm screw securing the light fitting.
2. Pull down lens to remove.
3. Replace with light bulbs of the same type (MAX 40W, 120V,
Candelabra Base Bulb). CAUTION: BULB MAY BE HOT!
OFF
ON
FIG. 6
METAL WIRES
SERVICE PARTS
KEY NO. PART NO.
5 97018550
9 99010370
23 B03295095
24 B03295094
27 98010831
28 B02300280
29 B03294757
230 98010828
236 99030347
237 99030342
332 98010834
415 99400048
Not shown 97018559
CAS R730090
- 97018557
- -
- B08999040
FIG. 7
FIG. 8
DESCRIPTION
Grid (Silver)
Grease Filter
Upper Lampholder
Lower Lampholder
Metal Wire
Lampholder
Light Fitting
Controls Closing
Blower Switch (Black)
Light Switch (Black)
Cover Controls
Strain Relief Bushing
Hardware Package
Blower Assembly
Socket Assembly
(Includes key No.24, 23, 28)
"40 Watt Max.Candelabra
Bulbs not included"
Non-Ducted Filter Kit
(purchased separately)