Jenn-Air JS42NXFXDW Guide D'installation page 20

Prepare Panels (custom wood panels only)
Door Panels
1. Place panels on a firm, covered, flat surface with the front
facing down.
2. Locate the 2 predrilled holes in the handle side edge of the
door panel.
3. Using the installation block as a guide for depth, attach a
shoulder washer with a hex head pointed screw (both
provided with refrigerator) into the predrilled door panel (2 per
door).
A. Shoulder washer and
hex head pointed screw
B. Installation block
4. For the mounting bracket, insert the hex-head pointed screws
(provided with refrigerator) into the wood at the top of the door
panels where they were predrilled.
NOTE: It is critical to use the ⁵⁄₈" screw, the longest length
provided, to attach the bracket to the top of the door panel.
A
A. U-shaped hole
B. Slot
20
5. Attach a mounting bracket to the top edge of each door panel
Top Grille Panel
1. Using the slotted hex-head screws (provided with refrigerator),
A
B
B
2. Using round-head screws (provided with refrigerator), attach
by placing the large end of the keyhole slot over the screws
and sliding the bracket so that the screws are centered in the
slots.
NOTE: Start with the screws in the center of the slots as
shown, then move the door panel, as necessary, to align.
A
A. Door panel
B. Mounting bracket
attach a mounting bracket to each side of the top grille panel.
IMPORTANT: See the "Parts Provided" section to select the
brackets designated for your installation.
Use the Integrated Grille brackets for a Fully Integrated
Grille installation with a full height grille.
Use the Standard Grille brackets for a Standard Integrated
Grille Installation with a closed or open soffit.
A. Top grille brackets
B. White, grille trim piece
(taped to refrigerator door)
the grille trim piece to the bottom of the grill panel.
NOTE: The grille trim is preinstalled on the panel kits.
B
A
B