BorMann BSS2450 Mode D'emploi page 6

E N
USING THE DUST BAG ASSEMBLY
The dust bag assembly provides a dustcollectionsystem for the sander. Sanding dust
is drawn up through the holes of the sanding disc and collected in the dust bag during
sanding.
TO ATTACH THE DUST BAG ASSEMBLY (See Figure 6)
Follow these directions to attach the dust bag assembly.
- Unplug the sander.
WARNING: Failure to unplug the tool could result in accidental starting causing possi-
ble serious injury.
- Slide the dust bag assembly onto the blower exhaust on the sander using a slight-
twisting motion.
TO EMPTY THE DUST BAG ASSEMBLY (See Figure 6 and 7.)
For more efficient operation, empty the dust bag when it is no more than half full.
This will permit the air to flow through the bag better. Always empty and clean the
dust bag thoroughly upon completion of a sanding operation and before placing the
sander in storage.
WARNING: Collected sanding dust from sanding surface coatings such as polyure-
thanes, linseed oil, etc. can self-ignite in your sander dust bag or elsewhere and cause
fire. To reduce the risk of fire always empty your dust bag frequently (10-15 minutes)
while sanding and never store or leave a sander without totally emptying its dust bag.
Also follow the recommendations of the coatings manufacturers.
Follow these directions to empty the dust bag assembly:
- Unplug the sander.
WARNING: Failure to unplug the tool could result in accidental starting causing pos-
sible serious injury.
- Remove the dust bag assembly from the sander.
- Remove the dust bag from the frame.
- Shake out the dust.
- Replace the dust bag on the frame.
- Replace the dust bag assembly on the sander.
OPERATING THE SANDER
See Figures 8 and 9. Follow these steps to operate the sander.
- Secure the work to prevent it from moving under the sander.
WARNING: Unsecured work could be thrown towards the operator causing injury.
WARNING: Keep your head away from the sander and the sanding area. Your haircould
be drawn into the sander causing serious injury.
- Place the sander on the workpiece so that all of the sanding disc surface is in contact
with the workpiece.
CAUTION:
Be careful not to let your hand cover the air vents.
- Start the sander and move it slowly over the workpiece.
- Make successive passes in parallel lines, circles, or crosswise movements.
NOTE: The front edge of the sander allows for flush sanding. See Figure 9.
- Turn the sander off and wait until the sanding disc comes to a complete stop before
removing it from the workpiece.
6
WWW.NIKOLAOUTOOLS.COM
DUST BAG ASSEMBLY
BLOWER
EXHAUST
Fig. 8
DUST BAG
ASSEMBLY
Fig. 6
BLOWER
EXHAUST
Fig. 7
FRAME
Fig. 9