Kenwood DDX57S Guide De Démarrage Rapide page 28

Connection/Installation
Ñ
Microphone unit
1) Check the installation position of the
microphone (accessory 1).
2) Clean the installation surface.
3) Remove the separator of the microphone
(accessory 1), and stick the microphone to
the place shown below.
4) Wire the microphone cable up to the unit
with it secured at several positions using tape
or other desired method.
5) Adjust the direction of the microphone
(accessory 1) to the driver.
1
Fix a cable with a commercial item of tape.
NOTE
• Swap the clips if necessary.
Ñ
Removing the trim plate
1) Use the extraction key (accessory 4) to lever
out the six tabs (three on the left part, three
on the right part).
2) Pull the trim plate forward.
28
Ñ
1) Remove the trim plate by referring to step 1 in
2) Insert the extraction key (accessory 9) deeply
3) With the inserted extraction key secured,
4) Pull out the unit halfway.
5) Pull the unit all the way out with your hands,
4
Removing the unit
"Removing the trim plate".
into the slot as shown. (The protrusion at the
tip of the extraction key must face toward
the unit.)
insert the other extraction key into the slot.
NOTE
• Be careful to avoid injury from the catch pins
on the extraction key.
being careful not to drop it.
9
9