GE HPS18BTNRBB Manuel D'utilisation Et Instructions D'installation page 5

Temperature Control
The temperature control adjusts the refrigerator from its
warmest to coldest settings.
Your refrigerator will come with the recommended
warmer temperature, turn the dial counter-clockwise
both compartments, turn the knob counter-clockwise to
refrigerator.
Sabbath Mode
This product is capable of entering a Sabbath Mode.
Sabbath mode requires that the control knob and light
switch are operated at the same time. The light switch
is located just to the left of the control knob. To enter
Sabbath Mode, turn the control knob to position 5,
then hold down the light switch. While the light switch
is held down, turn the control knob to position 3. Once
the control knob is in position 3, release the light
switch. When you release the light switch, the light will
turn off and the product is in Sabbath mode. To exit
Fresh Food Compartment Shelves
Shelf supports at various levels allow you to custom-space your shelves. Not all features are on all models.
Full-Width Shelves
Some models have a stationary tempered glass shelf or
two steel wire stationary shelves. These shelves can be
moved to another place in the fresh food compartment.
When placed correctly on the shelf supports, the shelf
will stop before coming completely out of the refrigerator
and will not tilt when you place food on it or remove food
from it.
CAUTION
with warm water when they are cold. Glass shelves and
covers may break if exposed to sudden temperature
changes or impact such as bumping or dropping.
Tempered glass is designed to shatter into many small
pieces if it breaks.
49-1000394 Rev. 2
Light Switch
Sabbath mode, enter the same control knob/ light switch
is not exited manually, it will end automatically after 74
it is in Sabbath mode, it will remain in Sabbath mode
after power is reconnected. Sabbath mode does not
deactivate the icemaker, if present. The icemaker must
be turned off manually by moving the icemaker switch
to the off position. The icemaker switch is located on the
Wire shelf - lift back end and pull forward to remove
3
Glass shelf - lift the front edge (1), push shelf back (2),
lift shelf up and pull forward (3) to remove.
2
3
1
5