Bosch GTA 2500 W Professional Notice Originale page 13

(8) Saw stand support
(9) Support locking mechanism
(10) Workpiece support locking knob
(11) Length stop
(12) Workpiece support
(13) Upper frame with locking mechanism
(14) Foot support
(15) "L" wheel
(16) "R" wheel
(17) Lower frame
(18) Support frame
(19) Fastening set
(20) Lock bolt
(21) Stop plate
(22) Hex nut
(23) Release button
(24) Holder set locking lever
(25) Stop
(26) Movable nut
(27) Nut for adjustment of the support locking mechan-
ism
(28) Nut for adjustment of the lock bolt
Screw for adjustment of the lock bolt
(29)
Technical Data
Saw stand
Article number
Length of saw stand without
table extension
Length of saw stand with table
extension
Saw stand height
Max. load bearing capacity (power tool + workpiece)
– Holder sets
Max. load bearing capacity (power tool + workpiece) with
table extension
– Holder sets
– Per table extension
Weight according to EPTA-Pro-
cedure 01:2014
Assembly
Items included
See the list of items included at the start of
the operating manual.
Bosch Power Tools
Check to ensure that all the parts listed below have been
supplied before assembling the saw stand:
No.
(1)
(2)
(13)
(17)
(14)
(15)
(16)
(18)
(19)
GTA 2500 W
3 601 M12 1..
mm 1044
Extra tools required (not included in the delivery):
– Cross-headed screwdriver
mm 2510
– Open-ended spanner (10 mm, 8 mm, 6 mm)
– Wrench, adjustable
mm 947
Assembling the Mobile Base Unit
kg 180
– Carefully remove all parts included in the delivery from
– Remove all packing material.
kg 130
– For assembly, follow figures A−E2.
kg 25
For figure B:
kg 32.2
For easier orientation, the wheels are marked ("R" for right-
hand wheel, "L" for left-hand wheel).
Note: Do not over-tighten the nuts. The screwed-together
parts must be able to move freely.
For figure D:
Ensure that the support frame (18) is installed in the correct
direction, as indicated by the "R" and "L" markings that
match the wheels.
Note: Do not over-tighten the nuts. The screwed-together
parts must be able to move freely.
Designation
Holder set
Saw stand with support (8)
Upper frame with locking mechanism (3)
Lower frame
Foot support
"L" wheel
"R" wheel
Support frame
Fastening set consisting of:
– Hexagon screws
M10 x 100
M10 x 55
M10 x 50 (self-locking)
M8 x 45
M6 x 45
– Cross-head screws
M8 x 50
– Washers
M10 x 29
M10
M8
M6
– Lock nuts
M10
M8
M6
their packaging.
1 609 92A 6JC | (11.05.2021)
English | 13
Quant-
ity
2
1
1
1
1
1
1
1
4
1
2
4
4
4
2
10
4
4
5
4
4