Publicité
Les langues disponibles
Les langues disponibles
Check Range Hood Operation
1. Check operation of the range hood by turning on the power.
2. The range hood controls are located on the right-hand
underside of the range hood.
A. Controls
B. Filters
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the
kitchen.
The hood controls are located on the right-hand underside of the
range hood.
C
B
A. Controls
B. Light switch
C. Fan switch
D. Fan speed switch
10
Complete Installation
A
B
RANGE HOOD USE
A
D
3. Move the light switch to "1" position. The night light should
turn on. Move the light switch to "2" position. The full lights
should turn on.
4. Move fan switch to "1" position. The fan should operate.
5. Move the fan speed switch to "1" position for low speed, "2"
position for medium speed or "3" position for high speed.
6. Move fan and light switches to "0" position to turn fan and
light off.
7. If range hood does not operate, check to see whether a
circuit breaker has tripped or a household fuse has blown.
Disconnect power supply and check that the wiring is
correct.
NOTE: To get the most efficient use from your new range hood,
read the "Range Hood Use" section.
Range Hood Controls
Operating the light
1. Move the light switch to the "1" position to turn range hood
light to night light setting.
2. Move the light switch to the "2" position to turn range hood
light to full light setting.
3. Move the light switch to the "Off" position to turn range hood
light OFF.
Operating the fan
1. Move the fan switch to the "On" position to turn the fan ON.
The fan will begin operating at the speed set on the fan speed
switch.
2. Move the fan switch to the "Off" position to turn the fan OFF.
Auto On Fan
The range hood is equipped with a sensor to automatically turn
on the fan when excessive heat is detected in the control area.
When the fan switch is in the "Off" position, this sensor will turn
the fan to high speed when necessary. When the heat decreases,
the fan will turn off.
When the fan switch is in the "On" position, the heat sensor is not
active and the range hood functions normally.
Adjusting the fan speed
The fan has 3 speed controls. Move the fan speed switch to "1"
position for low speed, "2" position for medium speed, or "3"
position for high speed.
Thermal Protector
The range hood is equipped with a thermal protector to avoid
overheating conditions. If the range hood shuts off while in use,
move the fan slider switch to the "Off" position to turn off the
range hood. Wait approximately 60 minutes, then move the fan
slider switch to the "On" position to restart the range hood.
Publicité
