Publicité
Les langues disponibles
Les langues disponibles
SilverCrest SADL 300 A1
• Use the measuring cup (10) provided to mix a specific quantity of water with the
essential oil. Always check the mixing ratio on the label of the essential oil! Using too
much can be damaging to your health or could cause damage to property. Follow
the manufacturer's instructions!
• Put the prepared mixture into the water
reservoir. For the device to work correctly, at
least the bottom of the water reservoir must be
completely covered with water. The maximum
water level is shown by the arrow marker
inside the water reservoir. The water must not
be higher than this marking.
• Replace the vapour chimney (2) and the light shield (1).
The aroma diffuser is now ready for you to use the diffuser function.
9.1 Switching between modes
You can use the buttons (6, 7, 8, 9) to select different mode combinations. The functions of
the buttons (6, 7, 8, 9) are described below:
Button 6 (diffuser function)
1st press
2nd press*
* After the diffuser function is switched off, the fan runs on for a few seconds to cool the
electronics in the device.
58 - English
Diffuser "ON"
Diffuser "OFF"
Publicité
