Publicité
Les langues disponibles
Les langues disponibles
9. Getting started
Connect to the mains by plugging the mains power adapter (11) into a mains socket which
complies with the power adapter specifications. Then insert the connector on the cable into
the power supply socket (5) on the diffuser base (3).
When the power supply is established, an alarm sounds and the device flashes
red. This is for safety reasons and indicates that the liquid in the aroma diffuser
must be changed after 72 hours at the latest in order to prevent the build-up of
bacteria. Press the button (8) for 3 seconds to confirm that the water container
has been cleaned and there is fresh water in the reservoir. This switches off the
alarm.
After 72 hours, the alarm and the alarm light are reactivated to remind you to
clean the water reservoir and change the liquid.
CAUTION! If the device is faulty or used incorrectly (too much liquid added),
liquid can leak out of the bottom of the device.
CAUTION! If there is no liquid in the water reservoir, the diffuser cannot be
switched on using the button (6).
However, the light effects can be adjusted using the button (9).
The parts of the aroma diffuser can be taken apart and put back together without tools. This
makes it easy to fill and to clean.
The procedure for filling is as follows:
• Lift up the light shield (1) and the vapour chimney (2).
SilverCrest SADL 300 A1
English - 57
Publicité
