shark Rocket AH452W Mode D'emploi page 9

IMPORTANT: Remove Brushroll from unit before rinsing.
IMPORTANT: Make sure Brushrolls are completely dry before replacing in the vacuum.
Make sure unit is off and cord is unplugged.
STEP 1
STEP 4
CLEANING THE POWERHEAD
TO ACCESS THE BRUSHROLL
1 Slide the Brushroll Cover Release Buttons
out.
2
Pull up to open the hood of the Motorized
Floor Nozzle.
3
Lift the tab on the Brushroll up to remove it
from the Motorized Floor Nozzle.
4 Remove any string, carpet fibers, or hair that
is wrapped around the Brushroll. The groove
on the Brushroll allows a pair of scissors to
cut the debris without damaging the bristles.
STEP 2
STEP 5
5 The Brushroll can be removed and rinsed
under running water. Let the Brushroll air-dry
completely before replacing in the Motorized
Floor Nozzle.
6
To reassemble, hold the Brushroll by the tab
and align the other end with the gear. Then
with the tab facing up, place the Brushroll in
the Motorized Floor Nozzle.
7 Close the Brushroll cover. Listen for a click
and make sure the release buttons are fully
closed.
1. 8 0 0 . 7 9 8 . 7 3 9 8
STEP 6
IMPORTANT: DO NOT place the Brushroll in the
dishwasher to wash or the dryer to dry. DO NOT
submerge the Brushroll in water.
IMPORTANT: Using a wet Brushroll in
the Motorized Floor Nozzle will void your
warranty.
STEP 3
STEP 7
8