Publicité
Les langues disponibles
Les langues disponibles
Hood is designed for installation under a kitchen
cabinet (Fig 1)
ducting out of kitchen. Refer to page 7 for details.
3. Reinforce cabinet with 1"x2" wood strips if additional
strengthening is required or if cabinets are framed.
4. Temporarily position the range hood in the desired
mounting location. Measure and mark the mounting
holes, duct and electrical locations with a pencil.
5. Drill/cut out the required openings for duct and
electrical access by following the dimensions on page
8; make sure the duct opening is large enough to apply
duct tape.
with washers provided.
7. Install electrical.
8. Install duct work and seal with duct tape.
10. Power up hood and check for leaks around duct tape.
11. If recirculating the hood refer to page 11 and 12 for
details.
(Shown as vertical ducting)
Push in on panel latch then pull panel down
Fig 2
13
electrical
Duct
opening
cutout
duct/silver
tape
Add 1x2
wood strips
Fig 1
Publicité
