Publicité
Les langues disponibles
Les langues disponibles
!
CAUTION: At least two installers are required
due to the weight and size of the hood.
2. Plum and mark center line.
not tighten all the way. Note: Wood blocking may need
to be added behind the drywall if no studs are present.
Wall anchors may also be used but check local codes
for compliance. Failure to use suitable wall anchors
and screws to hold the weight of the hood could result
in personal injury or damage to the cooking surface or
counter.
7. Hang hood onto the mounting screws and hand tighten each
8. Center and attach duct cover mounting bracket to wall just
9. Install electrical and duct work. Seal duct work with aluminum
duct tape.
10. Power up hood and check for leaks around duct tape.
* If using hood in recirculating mode you must secure the air
diverter plate onto wall before installing duct work and duct
brackets. Turn to page 10 for more details.
!
WARNING: Electrical wiring must be done by a qualified person(s) in
accordance with all applicable codes and standards. This range hood must be
properly grounded. Turn off electrical power at service entrance before wiring.
Cable Lock
be required by local codes. Check with local
requirements and codes, purchase and install
appropriate connector if necessary.
12-
FIG. A
Cable Lock
9
"
5/8
12-
3/16
"
26" min.
Publicité
