Electrolux ESF2450 Notice D'utilisation page 12

12 electrolux
Cleaning the spray arm
Regularly examine the spray arm. Remove
remaining food from the holes in the spray
arm.
Do these steps to remove the spray arm:
1. Turn the nut anticlockwise.
2. Remove the spray arm.
3. Fully clean the holes.
Technical data
Dimensions
Electrical connection - Voltage -
Overall power - Fuse
Water supply pressure
Capacity
What to do if...
The appliance does not start or stops during
operation.
If there is a fault, first try to find a solution to
the problem yourself. If you cannot find a sol-
Fault code and malfunction
• digital display shows
The dishwasher does not fill with wa-
ter
• digital display shows
The dishwasher will not drain
External cleaning
Clean the external surfaces of the appliance
and control panel with a damp soft cloth.
Only use neutral detergents. Do not use
abrasive products, scouring pads or solvents
(acetone, trichloroethylene etc...).
Frost precautions
If not possible, empty the appliance and
close the door. Disconnect the water inlet
hose and remove water from the water inlet
hose.
Width cm
Height cm
Depth cm
Information on the electrical connection is given on the rating plate
on the back of appliance.
Minimum
Maximum
Place settings
ution to the problem yourself, contact the
Service Force Centre.
Possible cause and solution
• The water tap is blocked or furred with limescale.
Clean the water tap.
• The water tap is closed.
Open the water tap.
• The filter in the water inlet hose is blocked.
Clean the filter.
• The connection of the water inlet hose is not correct. The
hose can be kinked or squashed.
Make sure that the connection is correct.
• There is a blockage in the sink spigot.
Clean the sink spigot.
• The connection of the water drain hose is not correct. The
hose can be kinked or squashed.
Make sure that the connection is correct.
Caution! Do not install the appliance
where the temperature is below 0 °C.
The manufacturer is not responsible for
damage because of frost.
54,5
44,7
48-49
0,8 bar (0,08 MPa)
10 bar (1,0 MPa)
6