SilverCrest SPUP 3 A1 Instructions D'utilisation Et Consignes De Sécurité page 32

In case if the charging process does not begin immedi-
ately, press the ON / OFF switch
charging process. The current battery status of the power
bank is displayed during the charging process by the
1
LED indicator
approx. 30 seconds.
To end the charging process, disconnect the USB charging
cable from the mobile device and the power bank
The power bank will switch off after approx. 30 seconds.
Or simply double click with ON / OFF switch
power bank and the LED indicator
Note: If you use all the USB ports, a voltage of 5 V will
output at the outputs. The maximum output current must
not exceed 3.0 A for all outputs.
Troubleshooting
= Problem
= Cause
= Solution
The power bank
It may be that the power bank is not connected properly.
Check that it is connected.
In order to charge the power bank, a power supply with
5 V and at least 3.0 A has to be used.
A connected device is not being charged.
The battery is drained.
Charge the battery.
32 GB/IE
. The LED indicator
5
is not being charged.
1
briefly to begin the
6
will switch off after
5
6
will switch off.
5
.
1
. The