Shop-Vac K Serie Manuel D'utilisation page 8

FILTER INSTALLATION AND MAINTENANCE (CONT'D)
2. Place the filter retainer onto the top of the foam sleeve. Hold the tank cover with one hand, turn the
handle on the filter retainer clockwise to lock the filter into place.
3. To clean the foam sleeve, hold the tank cover and turn the filter retainer counter-clockwise to loosen and
remove. Slide the foam sleeve up and off the lidcage. Shake excess debris off of the foam sleeve with a
rapid up and down movement.
4. Hold foam sleeve under running water for a couple minutes, rinsing from the inside of the filter. A water
wash is not always required, depending on the condition of the filter.
5. Check the filter for tears. If any are found, replace with a new filter.
Your vacuum can be used as a powerful blower. To use the blower feature, clear the hose
of any debris or obstructions. Insert machine hose end into blower port located on the
back of the tank cover. Twist the hose end slightly to tighten the connection. Caution
should be used when using as a blower due to the powerful force of air when using
certain attachments.
WARNING
DEBRIS FROM BEING BLOWN OR RICOCHETING INTO THE EYES OR FACE WHICH CAN RESULT
IN SERIOUS INJURY.
EMPTYING LIQUID WASTE FROM THE TANK
To empty liquid waste from the tank, turn the vacuum off and remove the plug from the wall outlet. Remove
the tank cover and deposit the liquid waste in a suitable drain. After tank is empty, return the tank cover to
its original position.
AUTOMATIC SUCTION SHUT OFF
The vacuum is equipped with an automatic suction shut-off that operates when picking up liquids. As the
level of the liquid rises in the tank, an internal float rises until it seats itself against a seal at the intake of
the motor, shutting off suction. When this happens, the motor will develop a higher than normal pitch noise
and the suction is drastically reduced. If this occurs, turn unit off immediately. Failure to turn unit off after
float rises and shuts off suction will result in extensive damage to the motor. To continue use, empty the
liquid waste from the tank as outlined in the previous section.
NOTE: IF ACCIDENTALLY TIPPED OVER, THE VACUUM COULD LOSE SUCTION, IF THIS OCCURS, TURN UNIT
OFF AND PLACE VAC IN UPRIGHT POSITION. THIS WILL ALLOW THE FLOAT TO RETURN TO ITS NORMAL
POSITION AND YOU WILL BE ABLE TO CONTINUE OPERATION.
No lubrication is necessary as the motor is equipped with lifetime lubricated bearings.
Before storing your vacuum cleaner the tank should be emptied and cleaned. The
power cord can be wound around the housing of the unit for convenience. Accessories
may be stored in the built-in tool storage provided on the tank cover on rear of unit.
Never allow liquids to sit in the tank for any extended period of time. The vacuum
should be stored indoors.
PAGE 8
BLOWER FEATURE
–
ALWAYS WEAR EYE PROTECTION TO PREVENT ROCKS OR
LUBRICATION
STORAGE