Maxima MOTOMAX 350 Instructions D'emploi page 82

Operating and maintenance notes
Furthermore, a specialist workshop authorised by us must be charged, among others, with the following
service in the scope of the annual customer service:
• Complete inspection of the entire power tool
• Professional motor cleaning (fuel tank, cylinder ribs, ...)
• Inspection and, if applicable, replacement of the wear parts, in particular annual replacement of the fuel
filter
• Best settings of the carburettor
8.9 Self-aid advice
Possible malfunctions:
• Engine does not start up
– Stop dial
 Turn the stop dial to the operating position "1" ......................  Chap. 6.1, page 24
– Spark plug
 Clean or replace ....................................................................  Chap. 8.5, page 34
– Old fuel
 Empty and clean tank, fuel up with fresh fuel ........................  Chap. 5.5, page 18
• Cut-off wheel is not accelerated properly
– Foreign body inside the wheel guard
 Clean wheel guard .................................................................  Chap. 8.1, page 30
– Ribbed belt tension too low
 Correctly set ribbed belt tension ............................................  Chap. 5.6, page 20
• Cut-off wheel rotates in idle operation
– Idle stop screw "T"
 Correctly adjust idle stop screw "T" .......................................  Chap. 8.3, page 32
– Coupling defective
 Service workshop
• Bad engine output
– Air filter clogged
 Clean air filter thoroughly .......................................................  Chap. 8.4, page 33
– Carburettor settings (L/H-settings)
 Service workshop
• Insufficient or no water supply in wet cutting
– Valve lever of the water supply line not opened
 Open valve lever ....................................................................  Chap. 5.7, page 20
– Connection of the water supply closed
 Open water supply
– Water supply pressure tank empty or pressure-relieved
 Replenish water or recover pressure supply
– Screen filter insert contaminated
 Thoroughly clean screen filter insert ......................................  Chap. 8.2, page 31
• Changed noise emission and motor does not reach high speeds
(only for models 881-12 and 881-14)
– Not enough engine oil in the oil tank
 Fuel up engine oil ..................................................................  Chap. 5.5, page 18
ENGLISH 38
MOTOMAX 350
