Important Safety Instructions - CAT MATE Elite 305 Mode D'emploi

FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference
that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
Hereby, Pet Mate Ltd., declares that this product is in compliance with
the essential requirements and other relevant provisions of EU
Directives. All Declarations of Conformity (DoC) may be viewed at
www.pet-mate.com/eudoc.
IMPORTANT: Dispose of damaged/faulty/end-of-life products in
accordance with locally applicable regulations for your country. EU: Refer
to Terms and Conditions section EU Waste Electrical and Electronic
Equipment (WEEE) Directive on www.pet-mate.com for more
information.
4

IMPORTANT SAFETY INSTRUCTIONS

• Read all instructions before installing or using this product.
• Register your purchase on-line at www.pet-mate.com (see guarantee).
• Do not allow children to play with this product.
• Inspect product regularly for correct operation and damage. Do not use if in doubt.
• This product is designed for use with pets only, as described in these instructions.
• The locking system of this pet door is not intended as a security device.
• This pet door is not a fire resistant door and must not be used where there is a risk
from fire spread.
• The installer of this pet door is responsible for complying with all relevant building
regulations.
• During installation of this pet door take appropriate care. Follow safety instructions
for all tools and wear appropriate personal protective equipment.
• Dispose of all packaging material properly. NOTE: Plastic bags could cause
suffocation - keep away from children and animals.
SAVE THESE INSTRUCTIONS
1. Introduction
Thank you for choosing the Cat Mate Elite I.D. Disc Cat Flap with Timer Control.
CAREFULLY READ THESE INSTRUCTIONS AND PROGRAM THE CAT FLAP
BEFORE YOU INSTALL IT.
The Cat Mate Elite I.D. Disc Cat Flap with Timer Control allows you to control
individual entry and exit of up to 9 cats. If required, an overriding timer function can
control the 4 way lock for ALL cats. Furthermore, it will allow you to monitor the
movement of up to 3 individual cats - showing when your cat last entered or left the
house, and how many hours since your cat last used the flap.
To ensure that your chosen settings cannot easily be tampered with, we have made
the control buttons so that they need to be pressed firmly to operate.
If you wish to stop any task (except programming) at any stage, the system will time
out after 60 seconds.
Settings will not be saved unless you press the 'PROG' button.
2. Fitting the Batteries
2.1 Remove the battery cover by pushing the battery cover upwards (see Fig. 2). The
cover will snap off.
2.2 Insert 4 x AA (R6) batteries as shown (Fig. 3), by sliding the 2 end batteries in first.
2.3 The cat flap will self-check for up to 60 seconds after which only the 'IN & OUT'
arrows will be visible on the LCD display. The flap is ready to program.
All popular batteries can be used including rechargeable batteries, but the low battery
indicator ( 4 , Fig. 1.) will only work correctly with alkaline batteries. Good quality
alkaline batteries should last approximately 12 months (depending on number of cats
and usage). You MUST NOT use lithium batteries.
5