Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Before Use
Prohibited ingredients
●
●
●
(Frozen when raw or after being boiled)
●
●
Ingredient preparation
1
2
3
4
●
●
●
●
GB16
Tips
How to use
Extracting
Preparations
1 Install parts on the motor housing and assemble the lid. (P. GB12-14)
2 Prepare ingredients. (P. GB15-16)
3 Place containers under the juice spout and pulp spout.
●
When using the frozen attachment, placing the pulp container is
not necessary.
4 Insert the mains plug into a house hold mains socket.
1
2
feeding tube slowly and
push them down by using
the food pusher.
●
Feed ingredients little by little
approximately every 5 seconds.
●
When using more than one kind of
ingredients, feed them little by little
alternately.
●
Do not force to push ingredients into
the feeding tube.
●
In the case of jamming of ingredients
(REVERSE) button for several seconds
3
(P. GB11).
After extracting is completed,
and close the spout cap.
After use
●
Pull out the mains plug.
●
Use the tip of cleaning brush to remove the pulp from juice spout and pulp spout.
●
Remove parts and clean them. (P. GB18-19)
Do not move the juicer by holding the lid or juicing bowl. (Dropping parts may cause injury.)
Note
●
Depending on ingredients (especially hard ingredients), their pulp may mix into the juice.
If pulp is disturbing your drink, strain your drink.
When pulp is not coming out or pulp is accumulating back of the pulp spout and top of the juice attach-
●
ment, turn the switch off and remove them.
Food pusher
Feeding tube
Open the
spout cap
Pulp spout
Juice spout
Pulp container
Juice container
GB17
Publicité
Table des Matières
