Before Use - Panasonic MJ-L500 Mode D'emploi

Before Use

-Disassembly and assembly of the parts-
Disassembling/Assembling attachments
● The following steps show how to disassemble/assemble attachments, using the juice attachment as
an example.
The frozen attachment can be disassembled/assembled in the same method.
To disassemble
1
Remove the
from the motor
housing.
2
attachment.
● Squeezing screw comes out with it.
Squeezing
screw
( Frozen
attachment
3
Remove the parts.
Filter
( Frozen
attachment
Rotating
brush
GB12
1
Make sure the gasket, rubber
plug and rubber brushes are
in place correctly.
● Gasket is located in the juicing bowl.
Top view
● Rubber plug is located outer bottom.
Push it in until
no gap.
)
Outer bottom view
● Rubber brushes are located on side of the
rotating brush.
See page GB19 for how to install the gasket,
rubber plug and rubber brushes.
The juicer may not work properly if
●
)
they are not assembled correctly.
To assemble
2
housing.
" mark on the motor housing and
" on the juicing bowl.
3
Attach the rotating brush and filter,
then set it on the motor housing.
" mark on the motor housing and
" mark on the juice attachment.
Top view
4
1 Insert the squeezing screw into the centre.
2 Rotate the squeezing screw and push it into
the hole until it stops.
● The lid cannot be closed if the squeezing
screw is not pushed down sufficiently.
● Be careful not to get your finger clamped in
the gap between the squeezing screw and
the filter.
( Frozen )
attachment
① ●
② ●
GB13